Produktbeskrivning
The PmodUSBUART module provides a USB to UART interface powered by the FTDI FT232RQ.
The PmodUSBUART uses the standard 6-pin connector to connect to the host device and a micro USB connector to connect to a PC or other USB capable device. The FTDI chip then converts the signal from UART to USB and vice versa.
USB to serial UART interface
Option to power the system board through the FTDI chip
Ships with a 6" 6-pin cable, and a 6-pin header
Note:
There are two UART signal pin assignment conventions in use on Digilent products. This product uses the new signal assignment convention. Connecting a product using the new convention with one using the old convention requires the use of a UART Crossover Cable (not included).
The PmodUSBUART uses the standard 6-pin connector to connect to the host device and a micro USB connector to connect to a PC or other USB capable device. The FTDI chip then converts the signal from UART to USB and vice versa.
USB to serial UART interface
Option to power the system board through the FTDI chip
Ships with a 6" 6-pin cable, and a 6-pin header
Note:
There are two UART signal pin assignment conventions in use on Digilent products. This product uses the new signal assignment convention. Connecting a product using the new convention with one using the old convention requires the use of a UART Crossover Cable (not included).