Product description
EK020 soldering kit with a relay that toggles state with a button press. Also referred to as an impulse relay or bistable relay. One pres activates the relay, another press turns it off again. The relay can also be controlled using external signals (L: 0-5V / H: 6-12V). Available inputs are toggle (switch state), set (activate) and reset (deactivate). EK020 is suitable when a small momentary push button is used to control equipment requiring a higher load than the button itself can handle.
Specifications:
- Supply voltage: 12 VDC
- Current (max): 40mA
- Switching speed (max): 2 Hz
- Relay contact: SPDT, NC or NO
- Switching capacity: 10 A/250 VAC or 10 A/30 VDC
- Dimensions: 45.7 x 35.6 mm
- Mounting holes: c-c 40.6 x 30.5mm, ø2.5mm
WARNING! This kit can operate with 230 VAC mains voltage. Live parts will then be exposed when the circuit board is connected to the mains, and contact may result in serious injury or death.
This kit should only be assembled, tested, and used by persons with sufficient knowledge of electrical safety and working with mains voltage. The circuit must always be disconnected from the mains before touching or modifying any components, connections, or other parts.
After assembly, the circuit board must be installed in a suitable enclosure that prevents accidental contact with live parts. Exercise extreme caution during connection, testing, and use.
