
Vill du jobba på Electrokit?
Just nu söker vi fler elektronikintresserade medarbetare för arbete med försäljning, kundtjänst och marknadsföring.
Butiken åter öppen
Vi har sedan den 1/12 åter öppet för besök i vår lilla butik.
Öppettider normalt måndag-fredag 10-16.
Välkommen!
MC9S08QG8CPBE DIP-16 8-bit MCU
1-9 | 99.00 SEK |
---|---|
10-24 | 89.10 SEK |
25+ | 74.25 SEK |
8 i lager
Beskrivning
Microcontroller based on the Motorola/Freescale HCS08 architecture.
Max CPU operating frequency: 20MHz
Flash: 8kB
RAM: 512B
* Background debugging system
* Breakpoint capability to allow single breakpoint setting during in-circuit debugging (plus two more breakpoints in on-chip debug module)
* Debug module containing two comparators and nine trigger modes. Eight deep FIFO for storing change-of-flow addresses and event-only data.
Debug module supports both tag and force breakpoints.
* Support for up to 32 interrupt/reset sources.
* ICS — Internal clock source module containing a frequency-locked-loop (FLL) controlled by internal or external reference; precision trimming of internal reference allows 0.2% resolution and 2% deviation over temperature and voltage; supports bus frequencies from 1 MHz to 10 MHz.
* XOSC — Low-power oscillator module with software selectable crystal or ceramic resonator range, 31.25 kHz to 38.4 kHz or 1 MHz to 16 MHz, and supports external clock source input up to 20 MHz.
* ADC — 8-channel, 10-bit analog-to-digital converter with automatic compare function, asynchronous clock source, temperature sensor, and internal bandgap reference channel; ADC is hardware triggerable using the RTI counter
* ACMP — Analog comparator module with option to compare to internal reference; output can be optionally routed to TPM module.
* SCI — Serial communications interface module with option for 13-bit break capabilities.
* SPI — Serial peripheral interface module.
* I2C — Inter-integrated circuit bus module.
* TPM— 2-channel timer/pulse-width modulator; each channel can be used for input capture, output compare, buffered edge-aligned PWM, or buffered center-aligned PWM.
* MTIM — 8-bit modulo timer module with 8-bit prescaler.
* KBI — 8-pin keyboard interrupt module with software selectable polarity on edge or edge/level modes.
* 12 general-purpose input/output (I/O) pins, one input-only pin and one output-only pin; outputs 10 mA each, 60 mA max for package.
* Software selectable pullups on ports when used as input.
* Software selectable slew rate control and drive strength on ports when used as output.
* Internal pullup on RESET and IRQ pins to reduce customer system cost.
* Single-wire background debug interface
* On-chip, in-circuit emulation (ICE) with real-time bus capture.
Mer information
ADC | 8 |
---|---|
Arkitektur | 8-bit |
Kapsel | DIP-16 |
Klocka | 20 MHz |
EEPROM | 0.05 |
Familj | S08 |
FLASH | 8 |
GPIO | 12 |
I2C | 1 |
PWM | 2 |
RAM | 0.5 |
SPI | 1 |
Matningsspänning (max) | 3.6 V |
Matningsspänning (min) | 1.8 V |
Timers | 3 |
UART | 1 |