Vill du jobba på Electrokit?
Just nu söker vi fler elektronikintresserade medarbetare för arbete med försäljning, kundtjänst och marknadsföring.
LF398N DIP-8 op-amp sample-hold
Denna produkt har utgått
The LF198/LF298/LF398 are monolithic sample-and-hold circuits which utilize BI-FET technology to obtain ultra-high dc accuracy with fast acquisition of signal and low droop rate. Operating as a unity gain follower, dc gain accuracy is 0.002% typical and acquisition time is as low as 6 µs to 0.01%. A bipolar input stage is used to achieve low offset voltage and wide bandwidth. Input offset adjust is accomplished with a single pin, and does not degrade input offset drift. The wide bandwidth allows the LF198 to be included inside the feedback loop of 1 MHz op amps without having stability problems. Input impedance of 1010? allows high source impedances to be used without degrading accuracy. P-channel junction FET’s are combined with bipolar devices in the output amplifier to give droop rates as low as 5 mV/min with a 1 µF hold capacitor. The JFET’s have much lower noise than MOS devices used in previous designs and do not exhibit high temperature instabilities. The overall design guarantees no feed-through from input to output in the hold mode, even for input signals equal to the supply voltages.
* Operates from ±5V to ±18V supplies
* Less than 10 µs acquisition time
* TTL, PMOS, CMOS compatible logic input
* 0.5 mV typical hold step at Ch = 0.01 µF
* Low input offset
* 0.002% gain accuracy
* Low output noise in hold mode
* Input characteristics do not change during hold mode
* High supply rejection ratio in sample or hold
* Wide bandwidth
Kunder som köpte den här köpte också
30 i lager
353 i lager
11 i lager