• 10 000 produkter

  • Snabb leverans

  • Frakt från 29 kr

Sök

Barometric Pressure Sensor - BMP085 Breakout

Art nr: 41011137

Tyvärr, produkten har utgått ur vårt sortiment

10 000 produkter

Snabb leverans

Frakt från 29 kr

Behöver du hjälp? Vi finns här!
Ring 040-298760 (måndag till fredag 10-16), eller mejla på info@electrokit.se

Produktbeskrivning

ÖppnaStäng

Produktbeskrivning

This is a breakout board for the Bosch BMP085 high-precision, low-power barometric pressure sensor. The BMP085 offers a measuring range of 300 to 1100 hPa with an accuracy down to 0.03 hPa in ultra-high resolution mode (that's 0.25m of altitude at sea level!) It's based on piezo-resistive technology for high accuracy, ruggedness and long term stability. These come factory-calibrated, with the calibration coefficients already stored in ROM. Writing your own code for it requires some math, but there are plenty of examples and libraries available (see below).

This breadboard-friendly board breaks out every pin to a 6-pin 0.1" pitch header. VCC can be from 1.8V to 3.6V; we typically run it on a clean, regulated 3.3V supply. The analog and digital supplies (VDDD and VDDA) are tied to a single header pin, but are separately decoupled. It connects to a microcontroller via I²C bus (also known as TWI, or on the Arduino, the "Wire" library).

We've made some minor hardware changes this time around to address some suggestions from the comment section including the addition of a solder jumper to disable the I2C pull-ups.

Features:

Digital two wire (I²C, TWI, "Wire") interface
Wide barometric pressure range
Flexible supply voltage range (1.8V to 3.6V)
Ultra-low power consumption
Low noise measurements
Factory-calibrated
Includes temperature sensor
Low-profile with a small footprint
Dimensions:

0.6" x 0.6" (15.24 x 15.24 mm)

Produktinformation

  • SKU:

    41011137

Relaterade kategorier