UAV v2 development platform

Part.no: 41003550
In stock: 3

Description

This is the new three axis UAV development board by Bill Premerlani. This board comes with a dsPIC30F4011 CPU, an MMA7260 three axis accelerometer and 3 LISY300AL gyros. It is intended for the do-it-yourselfer. By itself, it can be used to develop a three axis IMU controller. With the addition of an EM406 GPS receiver it can be used to develop a UAV controller for an RC car, plane, or boat. It comes with self-testing firmware that serves as a starting point for you to develop your own control and navigation firmware.

Features:

* Connection for a 20-Channel EM-406A SiRF III GPS Receiver (not included)

* PIC dsPIC30F4011 Controller (with onboard 3.3V and 5V glue logic)

* dsPIC runs at 120MHz with 16MHz resonator and PLL

* MMA7260 three axis accelerometer

* 3 LISY300AL gyros

* 4 Input, 3 output PWM points

* 6-Wire ICSP debug header

* 2 Separate colored status LEDs

* 3 General purpose switches

* On board 3.3V and 5V regulators (150mA max)

* 10m Positional Accuracy / 5m with WAAS

* GPS Outputs NMEA 0183 and SiRF binary protocol

* Spare USART connection for debugging

* 4 Spare digital I/O pins for debugging

Dimensions: 1.5 x 2.75 x 1.0"

Weight: 34 grams (controller and GPS)

Preview FilesFiles

Customers Who Bought This Item Also BoughtCustomers Also Bought

  • Dual stepper motor driver for Arduino

      Dual stepper motor driver for Arduino
    Dual stepper motor driver shield can drive 2 stepper motors at the same time by Arduino. It can work with the power supply from 4.75V to 30V. High accuracy controlling can be supported by Arduino for CNC milling machine. It uses the same stepper motor driver chip as EasyDriver, so you can use it as 2 EasyDriver modules on board. And there are all pins breakout as 3PIN electronic brick/ sensor brick interface.
    Part.no: 41013873
    In stock: 1 
    Buy
    $23.98