ArduPilot UAV controller ATMega168

Art.nr: 41003604
Tillverkare: Sparkfun
I lager: 6

Beskrivning

ArduPilot is a fully programmable autopilot that requires a GPS module and an infrared XY sensor such as the FMA module to create a functioning Unmanned Aerial Vehicle (UAV). The autopilot handles both stabilization and navigation, eliminating the need for a separate stabilization system. It also supports a "fly-by-wire" mode that can stabilize an aircraft when flying manually under RC control, making it easier and safer to fly. The hardware and software are all open source. The board comes with all the surface-mount parts already soldered, but requires the user to solder on connectors. Firmware is already loaded, but the autopilot software must be downloaded and loaded onto the board by the user. It can be programmed with the Arduino IDE. All details and instructions can be found at the project's home page.

Features:

* Controller designed to be used with autonomous aircraft, car or boat. Infrared sensor required only for aircraft.

* Based on a 16MHz Atmega168 processor. Total onboard processing power aprox 24 MIPS.

* Built-in hardware failsafe that uses a separate circuit (multiplexer chip and ATTiny processor) to transfer control from the RC system to the autopilot and back again. Includes ability to reboot the main processor in mid-flight.

* Multiple 3D waypoints (limited only by memory)

* Comes with a 6-pin GPS connector for the 1Hz EM406 GPS module.

* Has six spare analog inputs (with ADC on each) and six spare digital input/outputs to add additional sensors

* Supports addition of wireless downlink module for telemetry

* Can be powered by either the RC receiver or a separate battery

* Hardware-driven servo control, which means less processor overhead, tighter response and no jitters.

* Four RC-in channels (plus the autopilot on/off channel) can be processed by the autopilot.

* LEDs for power, failsafe status, autopilot status and GPS lock

Dimensions: 30mm x 47mm

Kunder som köpte den här köpte ocksåKunder köpte också

  • Anslutningskort för GPS-moduler

      Anslutningskort för GPS-moduler
    Kort för att bryta ut anslutningarna från GPS-moduler till hål med 2.54mm delning. Kontakten är en 1mm JST-stiftlist och används till ett flertal GPS-moduler, t.ex. GP-735, EM-406, EM-506, mfl.
    Art.nr: 41015016
    I lager: 10 
    45.00

  • GPS-mottagare EM-506 48 kanaler

      GPS-mottagare EM-506 48 kanaler
    The EM-506 GPS receiver from USGlobalSat based on the spectacular SiRF StarIII chipset. This complete module is built upon the same technology as the ET-301, but includes on-board voltage regulation, LED status indicator, battery backed RAM, and a built-in patch antenna! 6-pin interface cable included. This EM-506 GPS module is powered by SiRF Star IV, it can provide you with superior sensitivity and performance even in urban canyon and dense foliage environment. With SiRF CGEE (Client Generated Extended Ephemeris) technology, it predicts satellite positions for up to 3 days and delivers CGEE-start time of less than 15 seconds under most conditions, without any network assistance. Features: * 48-Channel Receiver * Extremely high sensitivity : -163dBm * 2.5m Positional Accuracy * Hot Start : 1s ' Warm Start : 35s / 15s with CGEE * Cold Start : 35s / 15s with CGEE * 45-55mA at 4.5-6.5V Dimensions: 30mm x 30mm x 10.7mm 16g including cable
    Art.nr: 41012712
    I lager: 2 
    419.00