This kit was designed to accompany Rob Faludi's Building Wireless Sensor Networks book, which is the comprehensive guide to ZigBee wireless networks. This kit includes many of the parts and pieces you will need to work through the examples in the book. If you're serious about learning everything you need to know about XBee networks, this kit and the book will get you up to speed in no time (or as long as it takes you to get through the book).
Note: The kit includes everything listed below and in the pictures. It includes many, but not all of the components needed. You may need an Arduino and some other components. This kit is not meant to be all-inclusive as you may already have some of the parts necessary.
Note: This product is a collaboration with Rob Faludi. A portion of each sales goes back to him for product support and continued development.
Includes:
1x - AA battery holder
2x - 10uf 25v capacitor
2x - 1.0uf 50v capacitor
1x - mini-USB cable (6ft)
1x - buzzer
1x - 9V wall adapter
1x - photocell
2x - clear breadboard
1x - 9V to barrel jack adapter
2x - XBee 2mW - series 2
1x - barrel jack
2x - straight male header (40-pin)
4x - 2mm 10-pin XBee socket
1x - LED assortment
1x - TMP36
1x - 5V black on green LCD (16x2)
2x - XBee breakout board
20x - 10K ohm resistors
20x - 100K ohm resistor
1x - 10K trimpot
20x - 300 ohm resistor
20x - 20K ohm resistor
20x - 200K ohm resistor
1x - XBee Explorer USB
1x - 33mm push button
1x - NPN transistor
1x - 3.3V voltage regulator
1x - jumper wire kit
