Gas

Gas sensor breakout board

Part.no:	41004066
In stock:	1

Description

Simple breakout board for the MQ - 3, MQ - 4, MQ - 6 and MQ - 7 gas sensors. All you need is VCC at 5V, GND, and a resistor to an ADC, that is it.

Note: This is the PCB only. Sensors listed below.

Dimensions: 16.8mm diameter

ACS756SCA-50B-PFF-T 5-pin hall effect sensor 79.00 Buy	Cable pealer low-cost 29.00 Buy	Test wire 0.64mm-0.64mm male/male 100mm kit 10pcs 39.00 Buy
Solder tip 4pcs for AP-2/VTSS4 89.00 Buy	DC-jack 2.1mm for wires 9.00 Buy	DC-plug 2.1mm plastic (2.1x5.5x9.5mm) 5.00 Buy

You have to sign in to rate this product.